Finisseur à béton Wirtgen SP 1600 en vente aux enchères

Out of service for 1 year.
This is a four-chassis paver designed for laying two-layer or single-layer concrete with the possibility of anchoring transverse and longitudinal spars with sliding pins on highways, roads or airport and other surfaces. Depending on the selected machine configuration, it is capable of laying concrete with a width of 6.0 m to 10.75 m and a thickness of up to 50 cm. The paver is guided in direction and height by electronic sensors from the guide wire or, newly, by the LAICA system. The weight of the paver with complete installation of elements to a width of 10.75 is 125 tons, the hourly output at the specified laying width is around 330-350 m2 per hour. The specified paver was manufactured in 1997. The last order was carried out in 2025, namely the road in the Čebraď tunnel - D1 - Slovakia.
LAICA system control.
Mth condition - no warranty.

Transport of the machine: the main body of the machine is transported as a whole on a large special low loader. Other parts of the machine must be transported by approximately 5-6 other semi-trailers.

In the photo gallery you will find photos of the loading/transport.
Overall worse condition - the machine is worn out, Condition corresponds to the age of the machine, Leaks of operating fluids, Due to long-term shutdown, service is required before putting into operation, Battery at end of its life-cycle, Corrosion, see photo gallery, Some moving parts may be seized or rusty, Broken plastic parts